Battery charge management IC

شريحة إدارة شحن بطاريات ليثيوم أيون AP5056 بتيار حتى 1A حزمة SOP-8 | AP5056 Single-Cell Li-ion Battery Charge Management IC 1A, SOP-8

⁨شريحة إدارة شحن بطاريات ليثيوم أيون AP5056 بتيار حتى 1A حزمة SOP-8 | AP5056 Single-Cell Li-ion Battery Charge Management IC 1A, SOP-8⁩ — ⁨1,750 IQD⁩ from ⁨Nanotik⁩ on SinaaStore. New, 1-month warranty. Delivery anywhere in Iraq for 5,000 IQD, cash on delivery.

Sold by Nanotik

Highlights

  • CC/CV charging for one lithium cell with 4.2V cut-off
  • Charge current adjustable up to 1A via a PROG resistor
  • Internal thermal regulation lowers current when hot
  • CHRG and STDBY status outputs for LED indicators
  • Surface-mount SOP-8 package with a thermal pad
  • No over-discharge or short-circuit protection
1,750IQD2,500IQDخصم 30%In stock
1

Ask about stock or request a better price

Price

1,750IQD

Its price has held at 2,500 IQD for the last 11 days.

Cash on delivery

Pay cash when the order reaches you — nothing upfront.

Delivery across Iraq

One flat 5,000 IQD fee for the whole order.

Learn more

1-month warranty

Learn more

About this item

AP5056 IC for charging a single Li-ion or Li-polymer cell with CC/CV charging and up to 1A charge current, in a surface-mount SOP-8 package.

The AP5056 is an integrated circuit for managing the charging of a single Li-ion or Li-polymer cell using constant current then constant voltage (CC/CV), with the cut-off voltage set to 4.2V and accuracy of about ±1%. It is an integrated circuit to be soldered onto a charging board, not a ready-made charger.

Charge current is set up to 1A with a single resistor (Rprog) on the PROG pin. The input voltage is 4.5V to 5.5V, that is, a USB 5V source. It has internal thermal regulation that lowers the current automatically when the chip heats up instead of letting its temperature rise, plus status outputs: CHRG while charging and STDBY when charging is complete, which drive LED indicators directly without transistors.

The chip supports trickle charging for very low batteries before full charging, automatic termination when current falls to about 1/10 of the set value, automatic recharge when the battery voltage drops, and prevention of current draw from the battery when the input is disconnected. The operating temperature range is -40°C to +85°C.

A design note from the listing: the chip is a linear regulator, and every difference between input voltage and battery voltage turns into heat inside it, so stay with a 5V input and solder the bottom pad onto a wide copper area. The chip provides no over-discharge or short-circuit protection, so add a separate protection board for the pack.

It comes in a surface-mount SOP-8 package with 8 pins and a thermal pad underneath, and the box contains a single AP5056 chip with no external components. The listing describes it as a common functional alternative to TP4056 chips in charging boards, so check the pin arrangement before any replacement. The condition is new with a 1 months warranty. It suits Arduino and ESP32 projects using an 18650 or LiPo battery, small power banks, and rechargeable portable devices.

Suitable for

  • Charging circuits inside portable devices
  • Arduino and ESP32 projects with an 18650 or LiPo battery
  • Small power banks and charging boards with a USB 5V input

Seller's description

شريحة متكاملة لإدارة شحن خلية ليثيوم أيون أو ليثيوم بوليمر واحدة بنظام التيار الثابت ثم الفولتية الثابتة (CC/CV)، مع فولتية فصل مضبوطة على 4.2V. يُضبط تيار الشحن حتى 1A بمقاومة واحدة على طرف PROG، وفيها تنظيم حراري داخلي يخفّض التيار تلقائياً بدل أن ترتفع حرارتها، إضافة إلى مخرجَي حالة لتشغيل مؤشرَي الشحن والاكتمال. تأتي بحزمة SOP-8 السطحية ذات الوسادة الحرارية السفلية.

أبرز المزايا

  • شحن كامل بنظام CC/CV بفولتية فصل 4.2V بدقة تقارب ±1%
  • تيار شحن قابل للضبط حتى 1A بتغيير مقاومة واحدة على طرف PROG
  • تنظيم حراري داخلي يخفّض تيار الشحن تلقائياً عند ارتفاع حرارة الشريحة
  • مخرجا حالة CHRG و STDBY يقودان مؤشرَي LED مباشرة دون ترانزستورات
  • شحن تمهيدي (Trickle) للبطاريات العميقة التفريغ وإنهاء تلقائي عند هبوط التيار إلى نحو عُشر قيمته
  • إعادة شحن تلقائية عند هبوط فولتية البطارية، ومنع سحب التيار من البطارية عند فصل الدخل

الاستخدامات الشائعة

  • دوائر الشحن المدمجة داخل الأجهزة المحمولة والألعاب الإلكترونية
  • مشاريع Arduino و ESP32 التي تعمل ببطارية 18650 أو LiPo
  • بنوك الطاقة الصغيرة ولوحات الشحن بمدخل USB 5V
  • الإضاءة المحمولة والأجهزة القابلة لإعادة الشحن

ملاحظة: الشريحة منظّم خطّي، وكل فرق بين فولتية الدخل وفولتية البطارية يتحوّل حرارةً داخلها، لذا التزم بمدخل 5V والحم الوسادة السفلية على مساحة نحاس واسعة. وهي لا توفّر حماية من التفريغ الزائد أو القصر، فأضف لوحة حماية منفصلة للحزمة.

What's in the box

شريحة AP5056 واحدة بحزمة SOP-8 سطحية بدون مكوّنات خارجية.

Specifications

ModelAP5056
Functionشريحة شحن خطّية لخلية ليثيوم واحدة (Single-cell Li-ion / LiPo)
Charging methodتيار ثابت ثم فولتية ثابتة (CC/CV)
Cut-off voltage4.2V بدقة تقارب ±1%
Max charge current1A قابل للضبط
Input voltage4.5V - 5.5V (مصدر USB 5V)
PackageSOP-8 سطحية (8 أطراف) مع وسادة حرارية سفلية
Operating temperature-40°C إلى +85°C
ضبط التيارمقاومة واحدة (Rprog) على طرف PROG
الحماية الحراريةتنظيم حراري داخلي يخفّض التيار عند ارتفاع الحرارة
مؤشرات الحالةCHRG أثناء الشحن و STDBY عند الاكتمال
الشحن التمهيديTrickle charge للبطاريات المنخفضة جداً قبل الشحن الكامل
إنهاء الشحنتلقائي عند هبوط التيار إلى نحو 1/10 من القيمة المضبوطة
التوافقبديل وظيفي شائع لشرائح TP4056 في لوحات الشحن
CategorySemiconductors, ICs & Electronic Components
More categoriesIntegrated circuits
ConditionNew
Warranty1-month warranty
SKUNTK-0534

Questions about شريحة إدارة شحن بطاريات ليثيوم أيون AP5056 بتيار حتى 1A حزمة SOP-8 | AP5056 Single-Cell Li-ion Battery Charge Management IC 1A, SOP-8

It currently costs 1,750 IQD (was 2,500 IQD) from Nanotik on SinaaStore (updated 17 November 2026).
No, the listing states it is for a single Li-ion or Li-polymer cell.
No, the listing says it provides no over-discharge or short-circuit protection, so add a separate protection board.
The listing describes it as a common functional alternative to TP4056 chips in charging boards; check the pin arrangement before replacing.
4.5V to 5.5V, that is, a USB 5V source.
Yes, Nanotik has it in stock. After you order, the shop calls you to confirm availability and your address before shipping.
It is new, as listed by the seller.
Yes, it comes with a 1-month warranty from Nanotik. The warranty is provided by the selling shop, not by SinaaStore.
Delivery to every governorate in Iraq costs a flat 5,000 IQD for the whole order, and you pay cash on delivery after checking the order with the driver. Nothing is paid upfront.
It is sold by Nanotik on SinaaStore, the online marketplace that brings together the shops of Baghdad's al-Sinaa Street and the rest of Iraq. Order it from this page and pay cash on delivery.