Power resistor

مقاومة قدرة بغلاف ألمنيوم 6Ω قدرة 50W | 6Ω 50W Aluminium Housed Wirewound Power Resistor

⁨مقاومة قدرة بغلاف ألمنيوم 6Ω قدرة 50W | 6Ω 50W Aluminium Housed Wirewound Power Resistor⁩ — ⁨2,625 IQD⁩ from ⁨Nanotik⁩ on SinaaStore. New, 1-month warranty. Delivery anywhere in Iraq for 5,000 IQD, cash on delivery.

Sold by Nanotik

Highlights

  • 6Ω and 50W with a heatsink
  • About 2.9A maximum current at full power
  • Wirewound element in a ribbed aluminium housing
  • Surface mounting with screws through side arms
  • New, with a 1 months warranty
2,625IQD3,750IQDخصم 30%In stock
1

Ask about stock or request a better price

Price

2,625IQD

Its price has held at 3,750 IQD for the last 11 days.

Cash on delivery

Pay cash when the order reaches you — nothing upfront.

Delivery across Iraq

One flat 5,000 IQD fee for the whole order.

Learn more

1-month warranty

Learn more

About this item

6Ω wirewound power resistor rated 50W in a ribbed aluminium housing, for test loads, battery discharge and braking circuits.

This is a power resistor of 6Ω rated 50W in a ribbed aluminium housing, with a wirewound resistance element embedded in insulating resin. The relatively low value means a higher current at the same voltage, so according to the listing it suits test loads, battery discharging and braking circuits, with a maximum current at full power of about 2.9A.

The 50W rating is conditional on a heatsink, because the real power depends on the contact area with the cooling surface. The metal housing carries heat into the mounting surface, so it is fixed with screws through the side arms onto a metal base or a heatsink of enough area. Running it in open air without a heatsink lowers the safe power considerably.

The stated specifications are a typical tolerance of ±5%, a typical operating range of -55°C to +200°C, non-polar terminals, and insulation between the resistance element and the metal housing. Self-inductance is not negligible because of the wound design, so do not rely on it in high-frequency circuits. At high currents use wire of a suitable cross-section and tighten the terminals firmly, because a loose connection heats up more than the resistor itself.

The listed uses are a dummy load for testing batteries, chargers and power supplies, a braking resistor in motor control circuits, a discharge resistor for large power capacitors, and a balancing load in inverter and audio amplifier testing. The item is new with a 1 months warranty, and the box holds one aluminium-housed power resistor, 6Ω / 50W.

Suitable for

  • Dummy load for testing batteries and chargers
  • Braking resistor in motor control circuits
  • Discharge resistor for large power capacitors

Seller's description

مقاومة قدرة بقيمة 6Ω وتصنيف 50W بغلاف ألمنيوم مضلّع وعنصر مقاومة ملفوف مغمور براتنج عازل. القيمة المنخفضة نسبياً تعني تياراً أعلى عند نفس الفولتية، فتناسب أحمال الاختبار وتفريغ البطاريات ودوائر الفرملة. الغلاف المعدني ينقل الحرارة إلى سطح التثبيت، لذا تُشدّ ببرغيين على قاعدة معدنية أو مشتت حراري كافي المساحة.

أبرز المزايا

  • قيمة 6Ω تسحب تياراً أعلى فتناسب اختبار المصادر تحت حمل حقيقي.
  • تصنيف 50W يتحقق عند التثبيت الصحيح على مشتت حراري.
  • تيار عبور يصل إلى 2.9A تقريباً عند القدرة الكاملة.
  • عنصر ملفوف بمعامل حرارة منخفض يحافظ على القيمة أثناء التشغيل.
  • غلاف ألمنيوم مضلّع يقاوم الاهتزاز والغبار ويوزّع الحرارة.
  • أطراف قوية تقبل مقاطع أسلاك كبيرة تناسب التيار العالي.

الاستخدامات الشائعة

  • حمل وهمي لاختبار البطاريات والشواحن ومزودات الطاقة.
  • مقاومة فرملة (Braking Resistor) في دوائر تحكم المحركات.
  • مقاومة تفريغ لمكثفات الطاقة الكبيرة.
  • حمل موازن في دوائر الإنفرتر والمكبرات الصوتية للاختبار.

ملاحظة: عند التيارات العالية استخدم سلكاً بمقطع مناسب وأحكم ربط الأطراف، فالتوصيل الرخو يسخّن أكثر من المقاومة نفسها؛ وثبّت الغلاف على مشتت لأن التشغيل في الهواء يخفض القدرة الآمنة إلى نحو الربع.

What's in the box

مقاومة قدرة واحدة بغلاف ألمنيوم 6Ω / 50W

Specifications

Resistance6Ω
Rated power50W (مع مشتت حراري)
Element typeسلك مقاومة ملفوف (Wirewound)
Tolerance±5% (نموذجي)
Maximum current at full power2.9A تقريباً
مادة الغلافألمنيوم مضلّع مع حشو راتنجي عازل
طريقة التركيبتثبيت سطحي ببرغيين عبر أذرع جانبية
عدد الأطرافطرفان (غير قطبية)
مدى حرارة التشغيل-55°C إلى +200°C (نموذجي)
المحاثة الذاتيةغير مهملة بسبب التصميم الملفوف
العزلعزل بين عنصر المقاومة والغلاف المعدني
سلوك التبديدالقدرة الفعلية تعتمد على مساحة التلامس مع سطح التبريد
CategorySemiconductors, ICs & Electronic Components
More categoriesPassive electronic components
ConditionNew
Warranty1-month warranty
SKUNTK-0377

Questions about مقاومة قدرة بغلاف ألمنيوم 6Ω قدرة 50W | 6Ω 50W Aluminium Housed Wirewound Power Resistor

It currently costs 2,625 IQD (was 3,750 IQD) from Nanotik on SinaaStore (updated 17 November 2026).
No, the 50W rating needs a heatsink, and running it in open air lowers the safe power considerably, according to the listing.
About 2.9A at full power.
By surface mounting with screws through side arms onto a metal base or heatsink.
No, the listing says self-inductance is not negligible because of the wound design.
Yes, Nanotik has it in stock. After you order, the shop calls you to confirm availability and your address before shipping.
It is new, as listed by the seller.
Yes, it comes with a 1-month warranty from Nanotik. The warranty is provided by the selling shop, not by SinaaStore.
Delivery to every governorate in Iraq costs a flat 5,000 IQD for the whole order, and you pay cash on delivery after checking the order with the driver. Nothing is paid upfront.
It is sold by Nanotik on SinaaStore, the online marketplace that brings together the shops of Baghdad's al-Sinaa Street and the rest of Iraq. Order it from this page and pay cash on delivery.