UPS boost module

كارت UPS رافع للفولتية 5V 3A يعمل ببطاريتي ليثيوم 18650 مع شحن وتفريغ | 5V 3A UPS Boost Module for 2x 18650 Li-ion Batteries with Charge and Discharge

⁨كارت UPS رافع للفولتية 5V 3A يعمل ببطاريتي ليثيوم 18650 مع شحن وتفريغ | 5V 3A UPS Boost Module for 2x 18650 Li-ion Batteries with Charge and Discharge⁩ — ⁨6,800 IQD⁩ from ⁨Nanotik⁩ on SinaaStore. New, 1-month warranty. Delivery anywhere in Iraq for 5,000 IQD, cash on delivery.

Sold by Nanotik

Highlights

  • Fixed 5V output at up to 3A
  • Works with two 18650 Li-ion cells (not included)
  • Instant switchover without rebooting the load
  • LED indicators for charge status and battery level
  • New, with a 1-month warranty
6,800IQD8,000IQDخصم 15%In stock
1

Ask about stock or request a better price

Price

6,800IQD

Its price has held at 8,000 IQD for the last 11 days.

Cash on delivery

Pay cash when the order reaches you — nothing upfront.

Delivery across Iraq

One flat 5,000 IQD fee for the whole order.

Learn more

1-month warranty

Learn more

About this item

Small UPS board with a fixed 5V output at up to 3A using two 18650 lithium cells, suited to keeping a Raspberry Pi, ESP32 or small camera running during power cuts.

This is a small uninterruptible power supply board that combines a lithium charger and a boost converter with a fixed 5V output at up to 3A. Two 18650 cells fit on it: it charges them when the external source is present while powering the load at the same time, and when the source drops out the supply switches to the batteries immediately without restarting the load, which matters for digital devices that suffer from rebooting.

Per the listing, it offers a 5V output at up to 3A, enough for a Raspberry Pi, simultaneous charge and discharge so the load runs while charging, two replaceable 18650 lithium-ion cells, protection against overcharge, deep discharge, short circuit and over-current, and LED indicators for charge status and battery level. Connection points are battery terminals and the 5V output on the board.

Listed uses: backup power for a Raspberry Pi, ESP32 and Arduino, small cameras and recorders running at 5V, 5V routers and modems and small network devices, and monitoring and recording systems that must not drop out. Make sure your device runs on 5V and draws no more than 3A.

A note from the listing: drawing 3A at 5V means about 4.5A from the batteries, so use a short, thick USB cable, because voltage drop in a poor cable triggers the low-voltage warning on a Raspberry Pi even when the board is fine. Ventilate the board during continuous full-load operation. Batteries are not included, and the box holds one UPS board with a 5V 3A output. It is listed as new with a 1-month warranty.

Suitable for

  • Backup power for Raspberry Pi, ESP32 and Arduino
  • Small cameras and recorders running at 5V
  • 5V routers and modems during power cuts

Seller's description

لوحة تغذية غير منقطعة صغيرة تجمع بين شاحن ليثيوم ومحول رفع فولتية بخرج ثابت 5V وتيار حتى 3A. تُركّب عليها خليتا 18650 فتشحنهما عند توفر المصدر الخارجي وتغذي الحمل في الوقت نفسه، وعند انقطاع المصدر تنتقل التغذية إلى البطاريات فوراً دون إعادة تشغيل الحمل. مثالية لإبقاء Raspberry Pi أو ESP32 أو كاميرا صغيرة تعمل أثناء انقطاع الكهرباء.

أبرز المزايا

  • خرج ثابت 5V بتيار يصل إلى 3A يكفي Raspberry Pi
  • انتقال فوري إلى البطارية يمنع إعادة إقلاع الأجهزة الرقمية
  • شحن وتفريغ متزامن لتشغيل الحمل أثناء الشحن
  • يعمل بخليتي ليثيوم أيون 18650 قابلتين للاستبدال
  • حمايات ضد الشحن الزائد والتفريغ العميق والقصر
  • مؤشرات LED لبيان حالة الشحن ومستوى البطارية

الاستخدامات الشائعة

  • تغذية احتياطية لـ Raspberry Pi وESP32 وArduino
  • كاميرات ومسجلات صغيرة تعمل بجهد 5V
  • راوترات ومودمات 5V وأجهزة الشبكة الصغيرة
  • أنظمة المراقبة والتسجيل التي لا يجوز انقطاعها

ملاحظة: سحب 3A على 5V يعني نحو 4.5A من البطاريات؛ استخدم كيبل USB قصيراً وسميكاً لأن هبوط الفولتية في الكيبل الرديء يسبب تحذير انخفاض الجهد على Raspberry Pi رغم سلامة اللوحة.

What's in the box

لوحة UPS واحدة بخرج 5V 3A (بدون بطاريات)

Specifications

Output voltage5V DC ثابتة
Output currentحتى 3A
Batteriesخليتا ليثيوم أيون 18650 (غير مشمولتين)
Board typeشاحن + محول رفع Boost + وظيفة UPS
CompatibilityRaspberry Pi وESP32 وArduino والأجهزة بجهد 5V
Battery drawنحو 4.5A عند الحمل الكامل
الشحن والتفريغ المتزامنيغذي الحمل ويشحن البطارية في الوقت نفسه
زمن التحويلانتقال فوري دون إعادة إقلاع الحمل
الحماياتشحن زائد، تفريغ عميق، قصر، تيار زائد
المؤشراتلدات لبيان حالة الشحن ومستوى البطارية
التبريدتحتاج تهوية عند التشغيل المستمر بالحمل الكامل
نقاط التوصيلأطراف بطارية ومخرج 5V على اللوحة
CategoryPower, Charging, Batteries & Energy Electronics
More categoriesInverters and converters
ConditionNew
Warranty1-month warranty
SKUNTK-0394

Questions about كارت UPS رافع للفولتية 5V 3A يعمل ببطاريتي ليثيوم 18650 مع شحن وتفريغ | 5V 3A UPS Boost Module for 2x 18650 Li-ion Batteries with Charge and Discharge

It currently costs 6,800 IQD (was 8,000 IQD) from Nanotik on SinaaStore (updated 16 November 2026).
No, the listing says the two 18650 cells are not included and the box holds only the UPS board.
The listing says the 5V output at up to 3A is enough for a Raspberry Pi, with a short, thick USB cable.
No, the listing describes an instant switch to the battery without restarting the load.
Yes, Nanotik has it in stock. After you order, the shop calls you to confirm availability and your address before shipping.
It is new, as listed by the seller.
Yes, it comes with a 1-month warranty from Nanotik. The warranty is provided by the selling shop, not by SinaaStore.
Delivery to every governorate in Iraq costs a flat 5,000 IQD for the whole order, and you pay cash on delivery after checking the order with the driver. Nothing is paid upfront.
It is sold by Nanotik on SinaaStore, the online marketplace that brings together the shops of Baghdad's al-Sinaa Street and the rest of Iraq. Order it from this page and pay cash on delivery.